7000 Work Stock Gas
The Work Stock class is designed for DAILY DRIVEN, on the road pickup trucks (full
bodied, gas pickups) with minor modifications. A valid DOT registration, state inspection and
license plate are mandatory. All entries will weigh 7000 lbs. or less with the driver.
Safety
• OEM equipment and seat belts.
Ballast
• Ballast is permitted.
• Nothing may be added to front of truck or cab that may act as ballast.
• Ballast may be added in the bed of the truck. If used, ballast must be fastened to the
bed.
Batteries
• Batteries must be securely mounted in the OEM location with a solid or metal hold
down. No bungie cords allowed.
Body
• The body must be the OEM truck body, including the full bed floor.
• The body must retain full sheet metal.
• Metal aftermarket hoods are allowed.
• Fiberglass hoods are permitted with a sheet metal or aluminum skin shield underneath
of at least .060” thick.
• The hood must be closed and securely latched while the vehicle is hooked to the sled.
• The complete OEM firewall and the OEM floor pan is mandatory.
Brakes
• 4-wheel hydraulic brakes are mandatory.
Chassis
• The OEM chassis mandatory.
• The engine must be in the OEM location for the body used.
• Wheel tubs, back-half conversions, tube chassis, etc. are prohibited.
Cooling System
• Radiators must be in the stock location and be of at least stock size.
Driveline
• An OEM or factory option transmission and transfer case are mandatory.
Engine
• The engine is limited to stock OEM make-specific spark ignition engine.
• Nitrous Oxide and Oxygen Extenders (Propane, Methanol, etc.) are prohibited
• Engine must be the OEM engine for the truck as intended by the manufacturer.
• Programmers or chips are allowed.
• OEM intakes only.
Suspension
• The vehicle must have a working suspension, front and rear.
• No blocked or solid suspensions will be allowed.
• Traction bars are allowed.
• Air suspension is allowed. Air compressors must be disconnected.
Fuel
• 93 octane or below pump gas only.
Exhaust
• Exhaust may be other than factory but must still be street legal.
• Headers are allowed.
Hitch
• The hitch must be a receiver style hitch and stationary in all directions.
• The hooking point must be the rear most point on the vehicle and must be rearward of
the stock location of the tailgate.
• Bumpers may not be notched or removed.
• No pulling from the bumper.
• Hitch height must not exceed 26 inches from the ground.
• The hooding point must have a straight clevis or a reese type with a minimum hole size
of 3.75 inches.
Tires
• Tires must be DOT rated street tires.
• No cut or altered tires.