Pennsylvania Antique Tractor Pulling Association



PATPA RULES 2018


 

Cut Tire Class

  1. Tires- 15.5 maximum to 7,000lb. 16.9x38 max 7,500-10,000lb, unless factory equipped.

  2. Tires can be top cut only.

  3. Hitch must be a minimum of 24” from rear axle centerline to farthest inside edge of clevis/hook point.

  4. Hitch must be solid. Fast hitch can move 1/2 “ in either direction.

  5. Drawbar height is 18” maximum.

  6. Cut tire class sled pace is 3.5 mph.

  7. Cut tire tractors will have a 100lb weight allowance on scale.

  8. Wheelie bars are mandatory for any cut tire class.

  9. Cut tire weight classes are 2500lb-10500lb in 500lb increments.


Uncut Tire

  1. No altered tires in uncut class.

  2. Tires- 15.5 maximum to 7,000lb. 16.9x38 maximum 7,500-10,000lb, unless factory equipped.

  3. If there is a discrepancy about a set of tires, bring to attention of track official.

  4. Uncut class will run factory RPMS plus 20%.

  5. Hitch must be a minimum of 24” from rear axle centerline to farthest inside edge of clevis/hook point.

  6. Hitch must be solid. Fast hitch can move ½ inch in either direction.

  7. Hitch height is 18” maximum.

  8. Uncut class will have a 100lb weight allowance on scale.

  9. Uncut weight classes are 2500lb-10500lb in 500lb increments.

  10. Wheelie bars recommended for this class. Flagman can disqualify hook if front end comes too high off ground.




Make a free website with Yola